JE-RIM2200
Features:
Vertical clamps, two-step closing the oil tank on the back side of the machine
Two small cylinders with high-speed mold opening and / or closing, the movable surface can be installed in any position; linear probe to check the relevant provision of mobile surface
The parallelism between the upper and lower surfaces of <0.08 mm
Built-linear sensor controls the stroke of the clamping piston with a precision of 0.05%
One set of optimized system plastification, plasticizing screw is driven by a hydraulic motor
Delay function for measurement and the delay time is adjusted
One to three tons omplek cylinder balance injection device with patented technology, balanced with three vertical injection cylinder injection from the center of the upper surface
One set of intelligent reverse action unit at the connection point between the injection unit and the plasticizing unit
The four-adjustment and the speed and pressure of injection and volume of fuel injection is controlled by a setting of the injector.
Machine specification and data sheet:
Model machine | Unit | JE-RIM2200 |
Clamping force | kN | 2200 |
Injection volume | CC | 22000 |
Mold open Stroke | mm | 480 |
Heating plate daylight | mm | 560 |
Min mold Height | mm | 80 |
Injection Presure | Kg/cm2 | 1750 |
Heating plate Dim. | mm | 550 x 550 |
System pressure | bar | 220 |
Oil pump Motor power | kW | 11 |
Heating plate Heating power | kW | 21 |
Total installed Power | kW | 35 |
Weight machine | tons | 6 |
Input Power Voltage | AC 380V, 50 Hz, 3P+N+PE | |
Control Power voltage | DC 24V |
The warranty period is as follows (all that is considered below from the date of sale of the machine):
Common parts of the machine: 13 months
Controller: 2 years
Hydraulic components: 13 months
Roller: 3 years
Screed panels: 2 years
The master cylinder 2 years
Машина литьевая, инжекционного типа JE-RIM2200 брошюра